New Teltonika RUTX50 and A-MIMO-3-V2-17 - Poynting 7-in-1 Antenna Abysmal Download Speeds (9 Viewers)

[zac]

Just a thought. Is your Poynting antenna connected to the RUTX50 using the Poynting SMA tails or do you use SMA extension leads to reach the RUTX50?

In the past I have had occasion to change out an extension lead as whilst externally it looked ok, it was not fully crimped (manufacturing fault) and was significantly compromising the signal transmission to the router.

No extensions, it comes direct from the antenna and connects directly into the sma ports. There is even this little boot that goes over the nut on each connection to ensure they are tight.

 

[Sasbo]

No extensions, it comes direct from the antenna and connects directly into the sma ports. There is even this little boot that goes over the nut on each connection to ensure they are tight.

Ah well, back to the drawing board. Hope you find a solution soon

 

[zac]

So Teltonika have not been very good at all with their assistance but Solwise.co.uk have been very good, and they are going to send me another Router and i will send this one back, i cannot ask for any more than that. It's just a shame Teltonika are not more helpful seeing as it's their product.

Hopefully this will resolve my issue, fingers crossed.

 

[zac]

The replacement router is here and so far it looks OK, this time though i have not touched the firmware so it's on stock firmware, doubt that makes any difference, but the in built speed test is now a lot more (see below).

Waiting on some SMA adapters before i can test properly as i sent them back by mistake but they were from the antenna box not from the rut box.

 

[zac]

Not sure it’ll make a difference to your issue as that sounds more fundamental, but worth a try.

Teltonika 1: Cell 1 Main
Teltonika 2: Cell 1 Aux/Div
Teltonika 3: Cell 2 Aux/Div
Teltonika 4: Cell 2 Main

Just a quick question, which one of the antenna ports on the back of the RUTX50 is Teltonika1? Is that from left to right as you look at it i.e. the USB is on the far right under teltonika 4 or between 3 and 4 to be more precise or is it the opposite way as they dont appear to be labelled 1/2/3/4

^{_{Subscribers  do not see these advertisements}}

 

[brocola]

zac 1-4 left to right when looking at the back, USB on the right

From Teltonika info, the important thing seems to be to match each 1-2 or 3-4 pair on the X50 to a single antenna Main-Aux/Div pair.

That was my specific problem - because I didn’t know to pay attention - one side of my X50 was connected to 2 x Main and the other to 2xAux/Div

In my noddy understanding, bear of simple brain and all that, I think it meant the 4x4 mimo wasn’t able to make best use of the correct antennas for the relevant frequencies - using a low band antenna for high frequencies etc.