If you know, you know. (2 Viewers)

[Big Colin]

And yes, it was an 8a$t4rd of a job. If It could go wrong it did. 3.5hrs of continuous swearing.

But there was light at the end of the tunnel. And I’m overjoyed with the result, not to mention the huge uprating.

Now to fit the towbar…

 

[steve69]

What would it cost if a professional had done it?
3.5 hrs of swearing might have persuaded me to get someone else to do it.

 

[Big Colin]

What would it cost if a professional had done it?
3.5 hrs of swearing might have persuaded me to get someone else to do it.

I asked myself that…. But I’m a marine engineer by trade and I’m used to working upside down in confined spaces

For this job I had the luxury of a pit to work in. The left hand bump stop was removed in about 3 minutes. The right hand one had seized solid, hence the welding. Even then I had to apply brute force ‘up and down’ with a chain ratchet and 2 cans of penetration fluid. Once out, it became obvious that the bump stop had been installed cross threaded at the factory. I had to re-tap and install new threads. After all that, one of the u-bolt nuts failed and seized on the thread. Out with the grinder… I’m not sure a ‘pro’ would’ve done any better, other than charge me for the privilege.

Would I do it again? No chance!

 

[dazandandrea]

Did mine and shockers earlier this year. Luckily all came apart fine .
Much better ride in it now.
Well worth doing.

 

[suavecarve]

Just sent the SiL a youtube video to see if it falls within his skill level as I cant lie down in the confined spaces and twist etc.

^{_{Subscribers  do not see these advertisements}}

 

[the1andonly]

When i did mine i threatened it with welder in position large bars and 24 hr soak of penetrating oil before i got under. one rediculously easy one not so but 4lb lump 'ammer and chisel worked a treat. I tried verbal encourougement but didnt work on its own.