I have done the usual googling and none of them mention stalling so wondering if any mechanically minded could advise please?
Driving away and it stuttered and flashed a message regarding injectors but it didn't stay on the screen long.
I then pulled out the drive and it stalled after 100 meters with the injector error. I was thinking not again
Switched it off and left it 30 seconds. It started up again as per normal. Got the van back to the drive.
I checked the ODB2 code and saw P0380 was up. But this is about heater coil and that doesn't make any sense in todays temperatures?
There was a pending P0089 which is fuel pressure regulator. This seems like a more likely candidate BUT.
Once I had written the codes down I reset to confirm. I wanted to see if the P0380 was an old code. I then drove it to the gate and reversed it back up.
Checked the codes again and P0380 was pending but not active and the P0089 code is nowhere to be seen.
Any suggestions welcome, ask any questions if I have missed any information?
Driving away and it stuttered and flashed a message regarding injectors but it didn't stay on the screen long.
I then pulled out the drive and it stalled after 100 meters with the injector error. I was thinking not again
Switched it off and left it 30 seconds. It started up again as per normal. Got the van back to the drive.
I checked the ODB2 code and saw P0380 was up. But this is about heater coil and that doesn't make any sense in todays temperatures?
There was a pending P0089 which is fuel pressure regulator. This seems like a more likely candidate BUT.
Once I had written the codes down I reset to confirm. I wanted to see if the P0380 was an old code. I then drove it to the gate and reversed it back up.
Checked the codes again and P0380 was pending but not active and the P0089 code is nowhere to be seen.
Any suggestions welcome, ask any questions if I have missed any information?