Reversing cameras.

[Cassette]

I bought it from RoadPro but I fitted it myself.

RoadPro were good to deal with for the purchase too.

I replaced the one that was fitted, but used the new cable and mirror monitor as supplied.

I followed the original cable route and used the old one to pull the new one through most of the way. I thought I was better replacing the cable rather than source adapters.

I picked the reverse signal up in the cab near the fuse box in the Ducato, rather than at the reverse light, I used the original ground and ignition live from the original install....which were near the radio head unit.

I’m still impressed with it now......and I still haven’t seen anything better IMO.

Thanks, yes I'd be happy to fit myself as well, my concern is pulling the new cable through, I guess tape to the old one and hope for no sharp turns!

 

[Manic]

Just a little note about wiring a rear camera, if the sma cable has a red wire built in, you don’t need to run a separate power feed and it earth’s through sma cable.
Like this type.
https://rover.ebay.com/rover/1/710-...0001&campid=5338547443&icep_item=264746549550

 

[XxAnthxX]

Thanks, yes I'd be happy to fit myself as well, my concern is pulling the new cable through, I guess tape to the old one and hope for no sharp turns!

Mine came in through a bathroom cupboard, then into the wardrobe and down through the floor, so most of the run was under the van and back in to the hab area where there was Fiat cables in the B pillar, I took it round the door step and to the right of the dash, into its ‘box’ which then went to the two power feeds and the ground, then the other video cable went up to the monitor.