Noticed my oven is loose and most of thescrews have fallen out ,, was going to just replace but oninspection I can see that when it was installed it was off centre and some of the screws only went into veneer not the Plywood and most of the holes are now too big or non existant ....
im going to have to remover the oven and refill the good holes and fit fillets around the edge to drill new ones ,, Not a big job
But what im asking is the procedure for unhooking the oven at the back gas pipe and ignition wire ????? so i can pull it ot to get at the wood to fix .
im going to have to remover the oven and refill the good holes and fit fillets around the edge to drill new ones ,, Not a big job
But what im asking is the procedure for unhooking the oven at the back gas pipe and ignition wire ????? so i can pull it ot to get at the wood to fix .