Fresh water level sensor / probe (2 Viewers)

[ItaMotorhomer]

Hi

My fresh waster level don’t work on my 2005 Burstner. It’s stuck on 75% no matter how much water is in the tank.

I’ve tried everything following suggestions on older posts, take the probe out of the tank clean it, check/clean the connectors but nothing.

Hi do I check if it’s the probe not working?

Can I bridge the pins on the connector will this send a signal back to the screen/controller ?

Where can I find a direct replacement at a decent price ?

Thank you

 

[ItaMotorhomer]

Photos of the prone attached if tose helps ?

Thanks

 

[Peavy]

That looks like a standard Schaudt type sensor. If you get 75% always, would mean brown and green with electric continuity. Check with a multimeter. Here's the wiring to check.

 

[1967bowesj]

Use the wiring diagram from Peavy just puta link cable between the pins, brown and white should show full.
If the panel still shows 3/4 is time to get panel checked

 

[ItaMotorhomer]

Thanks everyone will try and report back

^{_{Subscribers  do not see these advertisements}}

 

[Gellyneck]

Hi

My fresh waster level don’t work on my 2005 Burstner. It’s stuck on 75% no matter how much water is in the tank.

I’ve tried everything following suggestions on older posts, take the probe out of the tank clean it, check/clean the connectors but nothing.

Hi do I check if it’s the probe not working?

Can I bridge the pins on the connector will this send a signal back to the screen/controller ?

Where can I find a direct replacement at a decent price ?

Thank you

Diabalo Dane replaced his tank sensors a few years ago with these https://www.tankblanket.co.uk/shop/ and reported back issue resolved.

 

[Diabalo]

Diabalo Dane replaced his tank sensors a few years ago with these https://www.tankblanket.co.uk/shop/ and reported back issue resolved.

Ours are different, just stainless steel screws at set levels in the tank, not the 3 pronged top fitting type the OP is showing.
Mine are still working after all this time.

 

[DT]

Mine has lost the 50% reading completely but does seem to be 75% most of the time. Luckily with the Burstner on board tank a real easy job to eyeball the level.