Hi all, I have recently purchased a 4 birth Boxer (Elddis body) and have swiftly realised there are only the driver and passenger seats that have seatbelts fitted. After much frantic internet searches I could only realistically come up with the solution of swapping the single passenger seat for a bench style seat as there will only be 3 of us travelling at any time.
I located a bench seat from eBay but unfortunately it was from a later model and does not fit the original floor mountings. But even sitting the bench seat in place the back of the seat nearest the door was up against part of the wooden panelling that is behind the door pillar seat belt..
I am at a bit of a loss what to do , we bought the van to get away after going through a tough few years but at present we can't really use it safely or at all.
The rear set up is a 'U' shaped lounge and the only forward facing seat is not really suitable to retrofit a 3 point seat belt.
Im hoping someone may have had a similar issue and have a solution..?
Thanks for reading, if you got this far..!
I located a bench seat from eBay but unfortunately it was from a later model and does not fit the original floor mountings. But even sitting the bench seat in place the back of the seat nearest the door was up against part of the wooden panelling that is behind the door pillar seat belt..
I am at a bit of a loss what to do , we bought the van to get away after going through a tough few years but at present we can't really use it safely or at all.
The rear set up is a 'U' shaped lounge and the only forward facing seat is not really suitable to retrofit a 3 point seat belt.
Im hoping someone may have had a similar issue and have a solution..?
Thanks for reading, if you got this far..!