Sargent control panel (1 Viewer)

[Buster668]

The Sargent control panel I have has recently started to display the vehicle battery voltage as 0 or 0.1 (poor) when I know the battery is fully charged. What can I do to rectify this? I suspect it means that I cannot use the built in charger for charging the vehicle battery because the control panel thinks the battery is knackered when it’s not!

 

[rb62]

First course of action is usually remove control panel,disconnect ribbon cable,leave for a minute or two then reconnect.

 

[PhilandMena]

Check fuses.

 

[Buster668]

First course of action is usually remove control panel,disconnect ribbon cable,leave for a minute or two then reconnect.

Tried that…. No difference

 

[Buster668]

This also means that the control panel won’t allow me to switch between vehicle and leisure batteries

^{_{Subscribers  do not see these advertisements}}

 

[noni]

if you are looking for some one to repair or can give advice speak to Andy Carter in leicester. he fixed my control panel last week very nice chap.07549160204

 

[GeoffnDee]

If you have checked all of the fuses , Give Sargent technical a ring 01482 678981 they are normally very helpful

 

[Camper634]

If you have an auxiliary fuse box usually behind the drivers seat,I would check that for damaged connections into the bottom of the circuit board.Think it’s called an EM40 controller.