Removing and replacing badge on Burstner Motorhome

[VXman]

Finally recieved my replacement badge for the disintegrating one on my 2021 motorhome. It started disintegrating after 3 months of ownership and took over a year to get a replacement.

Anyway, moaning aside - any advice on how to to remove the old one and fix the new one on? Not going to drive 2 hours to the dealer for this even though it's under warranty.

 

[Oldrat]

Double up some dental floss, and slice behind me the old badge

refit with double sided tape

 

[Stealaway]

I use this stuff constantly - inside and out. Saves drilling and screw

DOUBLE SIDED TAPE 12mm 25mm 50mm Heavy Duty Strong Adhesive Sticky Everbuild | eBay

12mm, 25mm, 50mm or a Sample. 99p is for a Sample at approx. 50mm x 50mm square. of Double Sided Powerful Sticky Tape. “Mammoth Powerful Grip Tape – The Tape That Thinks It’s A Glue! This is a polyester fabric reinforced double-sided tape with a powerful.

www.ebay.co.uk

 

[NigelNovice]

Use a hot air gun to warm it up a bit and then use the dental floss idea

 

[Jonno1103]

As above but if no dental floss fishing line also does the job.

^{_{Subscribers  do not see these advertisements}}

 

[lottie6]

Finally recieved my replacement badge for the disintegrating one on my 2021 motorhome. It started disintegrating after 3 months of ownership and took over a year to get a replacement.

Anyway, moaning aside - any advice on how to to remove the old one and fix the new one on? Not going to drive 2 hours to the dealer for this even though it's under warranty.

View attachment 698335

Had the same problem....just replaced badge, only took 5 months to get. Used wood chisel to cut through bonding, I could get fingers to lift edge of badge then in with the chisel & when off cleaned up remains with same sharp chisel.
2021 model also.....must be a bad batch of badges!

 

[Go_buddy_go_]

Waiting for our replacement as the same has happened… ours is a 2021 too
Thanks for the tips