OBD Reader for 2003 Fiat Ducato 2.8JTD Advice Please (1 Viewer)

[scotjimland]

I've never owned one, never had a need, so know very little about them other than you plug them in to check for possible faults ..

So can someone kindly advise on what to buy, I had a look on ebay but don't want to throw away money on something that isn't up to the job..

Do they come with full instructions.. and how to interpret the codes ?

Are the muppet proof ...

 

[denisejoe]

Not sure the 2003 had an OBD port

 

[scotjimland]

Not sure the 2003 had an OBD port

yes.. under the steering column , seen it being used

 

[Clivefog]

Yes it does - under the drivers dash about knee high. Most readers will list faults , some will allow you to clear them. You may get a fault code which will need looking up, saves a fortune if you know what the problem is before it goes for repair.

 

[the1andonly]

Most will probably read standard error codes but unlikely to do any thing specificaly Fiat, and may only give a number to search.
Typicaly the Software of choice is Multiecuscan or Alfaobd the only 2 diy priced product to read fiat.

What software/ hardware do i need to read OBD2 Codes

This a much bigger question than first appears. If we limit it to what is a cost effective DIY solution to "read my Fiat and simple maintenance issues eg change the oil in my euro 6 or add a new MAF sensor" then the answer for me reduces to...

www.fiatforum.com

Dear me look i what i found in the resources area

What software/ hardware do i need to read OBD2 Codes

This a much bigger question than first appears. If we limit it to what is a cost effective DIY solution to "read my Fiat and simple maintenance issues eg change the oil in my euro 6 or add a new MAF sensor" then the answer for me reduces to...

www.motorhomefun.co.uk

^{_{Subscribers  do not see these advertisements}}

 

[JockandRita]

the1andonly. On the back of Jim's thread, can you recommend similar for a LHD 2006 3.0ltr Iveco Daily please, with the round 32/38 x pin OBD port?

Thanks,

Jock.

 

[the1andonly]

Iveco 38-pin Adapter Lead to 16-pin OBD-II for Iveco Daily models

Iveco 38-pin Adapter Lead to 16-pin OBD-II for Iveco Daily models - only £19.94 including VAT & UK delivery!

www.gendan.co.uk

On that page gendan refers to two different products so i suspect Multiecuscan is not appropriate. but bell Gendan is the best advice i can give.

MaxiECU Diagnostic System for Iveco Vehicles - Bluetooth / WiFi Interface

MaxiECU Diagnostic System for Iveco Vehicles - Bluetooth / WiFi Interface - only £129.00 including VAT & UK delivery!

www.gendan.co.uk

 

[Figaro]

I bought a cheap 10-12 quid OBD 2 reader to use on my focus. It successfully identified and removed a warning light.
I've connected to my '03 2.8 jtd and it's recognized it, but never needed to do anything as I've had no warning lights on the motorhome thankfully.
I think what it will do is pretty basic stuff.