Lighting fusing

[GrannieAnnie]

Hi we have a new to us Chasson Flash the 20a fuse has blown on the interior lighting I have replaced it but immediately blown again. The control panel is lit and the lights at the rear above the bed and toilet are fine but no lights in the kitchen and dining. Any suggestions please

 

[meanders]

If traditional lights a bulb has blown but the filament has dropped and shorted the bulb. LED can be more difficult to track down. Remove the bulbs if you can, replace fuse see if it blows. Assuming it doesn't, replace one by one. The dodgy one is likely to be visibly faulty.

Check the wiring diagram if you have it to see if the fuse is shared with anything else.

 

[Dave101]

If you have an electric drop down bed, is that working? If not working, it may be trying to go up with bulky pillows or such like preventing it from reaching the top... The electric table is usually on the same circuit, too.

 

[TheBig1]

20amps on a lighting circuit? If that;s right you have a real problem. Remove and test all lamps, but I would suspect a wire has come loose and shorting if it is blowing such a high current fuse

 

[GrannieAnnie]

Just been checking everything and there are two sockets for the 12v tv and satellite that are not working too. We do have all LED lights

^{_{Subscribers  do not see these advertisements}}