LED garage lights with double PIR sensor

[Muratti]

Hi everybody
I need help to install two LED lights in my motorhome garage. Van has two doors one on each side and I would like to install two PIR sensors covering each side inside the garage which will be activated when the garage doors are opened.. I want both lights ( which are also on each side)to come on whichever PIR sensor is triggered. Sensors are basic negative and positive in and out . I attach the photo. Any wiring suggestions please.
Cheers

Murat
Murat

 

[Lenny HB]

It would be easier to use magnetic reed alarm switches.

 

[TinaLes]

Wouldn't 1 PIR sensor ceiling mounted, fitted in a central position, cover the garage area as a whole?
Opening door ether side would then activate both lights as you want, as I would have hoped the PIR was not so directional with its fish eye lens, even if you had to wave an arm inside which I doubt you would need to do....try it out.
LES

 

[Cush]

What about a battery powered stick on type? Just a thought. Hope you get it sorted.

 

[dunnah01]

Could you use each PIR to switch the single light by joining the positive PIR outputs to the light and leaving the negative outputs disconnected or return through PIR if easier

^{_{Subscribers  do not see these advertisements}}

 

[autorouter]

Could you use each PIR to switch the single light by joining the positive PIR outputs to the light and leaving the negative outputs disconnected or return through PIR if easier

That could work, with a bit of luck. If not, I think you would need to connect negative output wire to the light also. And a link between the two PIR output negatives too.

 

[@ndy]

I’ve got 2 of these in my MH garage, one just inside each door, work a treat.

https://www.amazon.co.uk/dp/B09DP2XV1V?tag=mhf04-21