B2B not working

[TCG]

Hi
Can anyone please assist. Following Peterborough i departed with SOC of 60% after a 3 hour drive when i arrived home my SOC was 65% so i checked my Victron B2B via the app and this is what i got. never seen that message before, but having said that cant remember the last time i checked it.
Can anyone point me in the right direction of where to start looking, this is what i got with the engine running and the leisure batteries at 65%
My set up is 2x100 amp lithium - Victron B2B orion - Smart BMV - 300 watt solar - MPPT - Multiplus inverter/charger

 

[Tombola]

Has the jumper come loose from the slot maybe? if it has maybe worth a reboot

do you have a remote switch attached?


or the fuse could be dodgy, though this may or may not explain the 5% addition unless it blew half hour after setting off

 

[TCG]

Has the jumper come loose from the slot maybe? if it has maybe worth a reboot

do you have a remote switch attached?


or the fuse could be dodgy, though this may or may not explain the 5% addition unless it blew half hour after setting off

thanks Tombola
below is image of my jumper - i think i have a remote switch the grey wire but it only goes in one side of the jumper is this correct. i suspect the increase of 5% was solar charging, it was quite dull.

 

[Tombola]

Hmmmm, so it looks like you don't have the switch wire connected to both the bridge L+H connections, so yes its likely the other side of that switch is connected to the input live of the orion. Similar to how your battery master is connected.
check that switch and also the connection to the input live are ok I cant see the end of that wire in the pic.