12v control parnel button won't reset

[FayGrigg]

Dethleff Esprit, I have tried to turn off the 12v control panel deactivation, after charging the batteries and it wont reset? We still have no power to about 4 non-essential things and the 12v light is still not on. Help most appropriated.

 

[jezport]

Check all wires to the battery are connected

 

[GeoffnDee]

If you have a Schaut Electroblock EBL system fitted there is some information about resetting that may help if you have a look at www.aandncaravanservices.co.uk (Schaut Electroblock section)

 

[maison]

FayGrigg
Did you resolve this?

 

[FayGrigg]

No we think a relay must be gone.

^{_{Subscribers  do not see these advertisements}}

 

[autorouter]

Is your system an Electroblock (EBL)?, if so what EBL model is it? There are a number of relays inside an EBL. Which things are working/not working?

When you say you charged the battery, how exactly did you do this? Did you disconnect and remove the battery, charge with it still connected, etc?

 

[FayGrigg]

MODEL EBL 111
Things not working:
Igniter on stove
Extractor Fan above stove
2 lights above stove
Light in wardrobe cupboard(same side as stove everything else working)
We charged the 3 x lithium batteries by plugging into power source on the outside of MH. We have 700watts of solar and the batteries have been fulled up and used since then.
Thanks for your reply

 

[GeoffnDee]

Have you checked the fuses on the EBL marked Kreis ?

 

[Lenny HB]

If you turned of the battery on/off switch on the EBL they well known for not turning back on.
If that is what it is spray some contact cleaner in it and operate if a few times. WD40 often works if you can't get any contact cleaner.

 

[FayGrigg]

The switch works on and off but the ecoblock wont shut off.
The 12v light up on the control panel doesn't come back on.

^{_{Subscribers  do not see these advertisements}}

 

[autorouter]

MODEL EBL 111
Things not working:
Igniter on stove
Extractor Fan above stove
2 lights above stove
Light in wardrobe cupboard(same side as stove everything else working)

As GeoffnDee says, these things are usually on one of the 'general' circuits, from the fuses labelled Kreis1 or Kreis 2. Check the fuses (15A).

 

[autorouter]

If that doesn't work, check that the two data wires to the digital panel are seated correctly. The thin 12-way and 7-way connectors along the top of the EBL. maybe pull them out and re-insert them.

Is the water pump working OK? That has the same supply source as the 'Kreis' fuses, so it's useful to know if that is working, to narrow down the problem

 

[FayGrigg]

Have checked fuses and water pump works

 

[autorouter]

Next thing to check, are all the things that don't work on one single fuse? or are some of them on different fuses? Try removing fuse Kreis1, and see what doesn't work. Then replace it and try removing fuse Kreis2, and see what doesn't work.

I can see your name colour has gone from green to grey, which means you've used up your five free posts, and to post any more you have to subscribe and become a member. Subscriptions are what keeps the forum running, and none of the contributors gets a single penny of it.