Adria Twin, tambour door removal and refitting. Anyone done it? (1 Viewer)

[Andy MacD]

I need to re seal around the shower tray and it would be much easier if I could remove the tambour door. I don’t see an easy way to do it other than remove the roof rail. I’m a little hesitant though in case it’s a nightmare to re fit.

Has anyone done this and if so how did you do it and how easy was it?

Thanks.

 

[Burgo]

We had ours off to clean and lubricate it (see historic posts). With ours you just unscrew the 1/3 section of the top rail and then just open the door, letting it slide out of the 2/3 section still screwed onto the ceiling. Easiest with 2 px to refit it, and I wouldn't let the slats get unlinked so maybe get a bit of a strap around them as you feed them off the top rail.

 

[Andy MacD]

Adria is different. Top rail is all one piece.

 

[Andy MacD]

I’ve come to the conclusion that there is no easy way to remove the tabour door on a Twin. I’ve unscrewed the top rail but that didn’t help. I think the only way they could have built it was to install the door then install the washroom wall after.

I’ve re sealed the shower tray as best as I could and hope I never need to remove / repair the door.